Before you all jump on me and say this has been covered before, I've looked at SS archive and just want to go over it again so if I decide to sell it - The buyer gets what there expecting or it goes back into the box.

I've read about west coast and east cost even different pressing plants - so just need some clarity

On both sides of the run-out you can clearly see a circle with the MR stamp inside - also in the runout is the following

A side

ZXSE 12304 This is on the lefthand side of the MR stamp

On the righthand side is

A triangle followed by 100301 - X

B side Up to the rooftop

Run out markings

 ZXSE 12303 This is on the lefthand side of the MR stamp

On the righthand side is

A triangle followed by 100301 

As always any advice and help greatly appreciated - Thanks

 

That's a 70s re-press

As above

Cheers guys all good 

Bootleg, the matrix number is from mid 1976

Defo boot as stated plastic will be styrene too